5C650 无线鼠标 Wireless mouse

按键布局

1，左键；2滚轮按键；3，右键；4，充电口；5，DPI；6，开关；7，侧键1；
8，侧键2；9，底贴；10，接收器。

产品规格

鼠标尺寸： 1 1 8 ^ { \star } 6 1 . 8 ^ { \star } 3 7 . 8 \mathsf {mm }
·产品重量：约60g
* 连接方式：蓝牙/2.4G/有线模式
，充电电压/电流： \mathsf { D C S V = } 2 5 0 \mathsf { m A }
电池容量：500mAH
·充电接口：USB-C
·DPI速度可循环调节分别为：800-1600-2400-3200-6400-12000DPI可根据需求定制DPI数值，初始默认为1600

·回报率:125Hz/250Hz/500Hz(默认)/1000Hz

连接方式说明

蓝牙连接方式

1.底部电源开关向下拨，屏上提示搜索字符慢闪提示，同时长按左中右键5S，搜索字符快闪进入配对状态，设备搜索到对应蓝牙名后连接，连接成功后，屏上BT字符长显，提示连接成功，RGB灯效亮起。
2.Win10系统搜索到蓝牙名AULA-SC650，点AULA-SC650，进入配对，配对成功，蓝牙符号常亮2秒，显示已连接成功。

2.4G连接方式

·开关切到2.4G模式，插入接收器，连接成功。

注：出厂默认已对好码可直接使用，无需重新对码。如果需要重新对码，切到2.4G模式，长按左中右按键5秒屏幕闪烁Pairing一2.4G,插入接收器进去电脑USB里，鼠标跟接收器距离必须保持在10cm以内插入电脑USB(重点注意)，即可连接成功。

灯效模式说明

1.灯效模式切换：同时按前侧键 ^ + 中键，
2.灯效模式：波浪、霓虹、巡回闪、YOYO球、单向闪、循环呼吸、灭灯

休眠模式说明

鼠标静止1分钟后，显示屏熄灭，进入一级休眠模式。
·鼠标静止10分钟后，进入二级休眠模式。
注：MAC系统模式下电脑休眠状态下需要一分钟鼠标才可移动唤醒。未到1分钟只能按键唤醒。

充电指示说明

在使用过程中发现有停顿或光标移动不顺畅时，说明锂电池电量不足，需要对电池充电。
低电灯：显示屏电量显示闪烁 (电压低于3.33V以下，提示要充电)
充电时：显示屏电量呈流水变化。
注意：给鼠标充电禁止使用高功率手机快充，有可能造成充电IC烧毁，建议使用配送充电线及普通5A以下充电头给产品充电。

安装使用说明

电脑系统需求：

操作平台Windows2000/WINXP/WIN7/WIN8/WIN10,在Win95，Win98系统下，可能需要驱动程序。
配置有USB1.1或以上版本端口。

保修事项说明

尊敬的用户：

感谢您购买狼蛛系列产品！本质保卡是狼蛛产品的三包凭证，由用户自己保存。凭此质保卡您将享受狼蛛为您提供的产品售后服务。此质保卡每个产品一份，遗失不补，敬请妥善保管。

一、凭此卡您将享受以下权利及服务：

1、退货服务：自产品售出之日起七日内，产品出现质量问题，根据国家"三包服务”规定，在产品外观与包装完整的情況下，将产品退还给销售商或狼蛛指定地点，凭购买时的有效凭证，退回您支付的产品货款。2、保修服务：自购买日起12月内出现产品性能故障情况经由狼蛛售后服务中心检测确定，可免费享受维修服务。

二、以下情況不属于免费服务范围：

1、超出规定的质保期限：

2、不能出示产品有效质保凭证或产品原序列号标签有涂改、替换、撕毁等现象的;
3、产品上沒有序列号或质保凭证上的产品型号与产品实物不符的；
4、非正常使用、维护、保管所导致的故障和损坏；
5、非我公司授权的维修人员对产品维修、更改或拆卸而造成的故障或损坏；6、意外事故或其他不可抗力造成的故障或损坏；
7、销售人员承诺的产品之外的服务及附加的配件或赠品不在本保修服务范围之列;
8、因电源、电压不稳而导致的故障或损坏。

key layout

1. Left click; 2 scroll wheel buttons; 3. Right click; 4. Charging port;
5， DPl; 6. Switch; 7. Side key 1; 8. Side key 2; 9. Bottom sticker;
10. Receiver.

Product specifications

· Mouse size: 1 1 8 ^ { \star } 6 1 . 8 ^ { \star } 3 7 . 8 \mathsf {mm }
· Product weight: 60g
· Connection method: BTh/2.4G/Wired Mode
· Charging voltage/current: { \mathsf { D C S V } } { \mathsf { = } } 2 5 0 { \mathsf { m A } }
·Battery capacity: 500mAH
·Charging interface: USB-C
·DPl speed can be cyclically adjusted to 800-1600-2400-3200-6400-12000 (default: 1600 with display screen)
·Rate of return125Hz/250Hz/500Hz(Default)/1000Hz

Connection method description BTconnectionmethod

1、Turn the bottom power switch down to BT mode, and the screen will prompt a slow flashing search character prompt.Simultaneously press and hold the left,middle,and right buttons for 5s to quickly search for characters and enter pairing mode After the device searches for the corresponding BT name and connects successfully, the BT character will be displayed on the screen for a long time, indicating successful connection,and the RGB light effect will light up.

2、The Win10 system found the BT name AULA-SC650, clicked on AULA-SC650,entered pairing, successfully paired, the Bluetooth symbol stays on for 2s,and the connection is displayed as successful.

2.4G connection method

·Switch to 2.4G mode，insert receiver,connection successful.

Note: By default, the code has already been aligned at the factory and can be used directly without the need for re alignment. If you need to re code, switch to 2.4G mode, long press the left, middle,and right buttons for 5 seconds,and the screen will flash, Pairing- * 2 . 4 \mathsf { G } , Insert the receiver into the computer USB,and keep the distance between the mouse and the receiver within 10cm. Insert the computer USB (please note) to successfully connect.

Lamp Effect Mode Description

·Lamp effect mode switching: Press the front button and middle button simultaneously, ·Light Effect Modes: Wave, Neon, Touring Flash,YOYO Ball, Unidirectional Flash,Circular Breathing, Off Light

Sleep mode description

· After the mouse is stationary for 1 minute, the display screen will turn off and enter the first level sleep mode.
·After the mouse is stationary for 10 minutes,it enters the second level sleep mode.
Before 1 minute, you can only press the button to wake up.
Note: In MAC system mode, it takes one minute for the mouse to move and wake up the computer in sleep mode.

Charging instructions

·When there is a pause or the cursor movement is not smooth during
use,it indicates that the lithium battery is low and needs to be charged.
·Low light: The battery level on the display screen flashes (if the voltage
is below 3 . 3 3 \mathsf { V } , it prompts to charge)
·When charging: The battery level on the display screen shows a
flowing change.
Note: When charging the mouse,it is forbidden to use high-power mobile phone fast charging,which may cause the charging IC to burn out. It is recommended to use the provided charging cable and a regular 5A or lower charging head to charge the product.

Installation and usage instructions

Computer system requirements:

The operating platform is Windows 2000/WIN XP/WIN7/WIN8/WIN10 and drivers may be required on Win95 and Win98 systems. Equipped with USB 1.1 or above ports.

Explanation of warranty issues

Dear users

Thank you for purchasing tarantula products! The warranty card is a three-guarantee certificate for tarantula products,which is kept by the user.With this card, you will enjoy after-sales service provided by Tarantula. This warranty card is one for each product. Lost cannot be replaced, please keep it properly.

I.With this card, you will enjoy the following rights and services:
1. Return service: within seven days from the date the product is sold,if the product has quality problems,according to the national "three guarantees" regulations, the product will be returned to the seller or the wolf spider when the product appearance and packaging are complete. Location,with the valid voucher at the time of purchase, refund the product payment you paid.
2.Warranty service: If there is a product performance failure within 12 months from the date of purchase, the tarantula after-sales serviceThe service center confirms the test and can enjoy the maintenance service free of charge.
II. The following situations do not belong to the scope of free services:
1. Exceeding the stipulated warranty period;
2. Failure to show the valid product warranty certificate or the original
serial number label of the product has been altered, replaced, torn,etc.;
3.There is no serial number on the product or the product model on
the warranty certificate does not match the actual product;
4. Failure and damage caused by abnormal use,maintenance and storage;
5. Failure or damage caused by repair,replacement or disassembly of
the product by maintenance personnel not authorized by our company;
6. Failure or damage caused by accident or other force majeure;
7. Services other than the products promised by the sales staff and
additional accessories or gifts are not covered by this warranty service;
8. Failure or damage caused by unstable power and voltage. Commissioned :Shenzhen Suoai Electronics Co.,Ltd 委托方：深圳市索艾电子科技有限公司
Commissioned Party (Manufacturer） :Dongguan Suoai Electronics Co.,Ltd 受委托方（制造商）：东莞市索艾电子科技有限公司 Suoai Industry Park,Huayu Street Changlong
Village Huangjiang Town Dongguan City
Guangdong Province.
广东省东莞市黄江镇长龙村华裕街 索艾产业园
客服电话：400-678-0255 0769-86911118
工作时间：08:00-12:00 13:30-17:30
周一至周五（法定节假日除外）
狼蛛新浪微博：weibo.com/aula
狼蛛腾讯微博：t.qq.com/aula2012
狼蛛官方网站：www.aulacn.com
执行标准号：GB/T26245-2010
MADEIN CHINA