150X800MM自然原木系列NATURALWOODGRAINBRICKSERIES

NO:FS81501

SIZE:150x800mm

NO:FS81502

SIZE:150x800mm

NO:FS81504

SIZE:150x800mm

NO:FS81505

SIZE:150x800mm

NO:FS81506

SIZE:150x800mm

NO:FS81507

SIZE:150x800mm

NO:FS81508

SIZE:150x800mm

NO:FS81509

SIZE:150x800mm

NO:FS81510

SIZE:150x800mm

NO:FS81511

SIZE:150x800mm

NO:FS81512

SIZE:150x800mm

NO:FS81513

SIZE:150x800mm

木纹砖的铺贴使用介绍INTRODUCTIONOFWOODGRAINTILESPAVEMENT

1、确定方案：常用木纹砖的铺贴方式，除了与传统的陶瓷墙地砖一样的井子形中规中矩，横平竖直的铺贴方法外，木纹砖还有人字形、工字形、斜形菱线等铺贴方法。铺贴方式可谓是多种多样，各有千秋，所以一定要与设计师一起先确定方案。
2、找平：所谓找平，即时在铺木纹砖前，应对铺贴的建筑物地面或墙面表面进行处理。如地面、内墙、外墙等。消除表面的附着物，用半湿水泥沙混合铺平。
3、弹线：弹线即是指用一段长的细线，涂上白灰货墨汁，确定砖的中轴线，然后按线铺贴。
4、选砖：要看计划铺的砖的品种，挑选出来分门别类放好。比如说铺地木纹砖、上墙的木纹砖、地脚线的木纹砖等要区分开来，以免铺起来弄混了。
5、浸砖：木纹砖与抛光砖、仿古砖一样要浸泡水，要用自来水或清水，不能用浑水或脏水，更不能用油污水；浸泡时间不需太长时间，也就是说，泡湿即可。（瓷片则一定要泡透才能铺贴）
6、混浆：水泥沙应以1：2的比例混合，应采用标号低于200的水泥，标号太高的水泥会对木纹砖形成内应拉力，严重的会拉裂木纹砖。
7、涂浆：取出浸泡好的木纹砖，擦干木纹砖的水渍，将水泥浆均匀涂抹在木纹砖背面，砂浆厚度在2-3厘米，随即将木纹砖往地面水泥沙面上铺，用木锤轻轻敲击木纹砖砖面，直至铺平平整、对线整齐为止。
8、铺贴：铺贴要注意木纹砖纹理顺序，注意看木纹砖砖底标示箭头等，木锤敲打避免空敲，力量要均衡，用力避免过大或过小。最好应用铺砖用的塑料十字架，这样可以更好给木纹砖定位。木锤敲打木纹砖缝反溢的水泥浆用海绵或抹布抹平即可。高档的木纹砖一般缝隙小于1毫米，不需专门填缝。
9、修整：木纹砖铺好，水泥还未完全干透，即可用肉眼观察或用水平尺测量，按照标准对木纹砖进行修整。检查砖铺贴的平整度，砖缝直线度等。发现问题，马上修整，严重的撬开木纹砖重新铺贴。
10、填缝：如要填缝则待水泥干了后用铁钩勾缝，再配以搭配颜色的填缝剂填缝。

1.Determinethesheme:Thecommonpavingmethodofwood-grainbricksisnotonlythewellshapedandregularorzontal andverticalpvingetodlietraditiolraicwalldlootilsutlotrngoneladeod lineandotherpavingmethods.Itmaybesaidthatthewayofpavingisavarietyof,eachhasitsownmerits,sowemustdecide the plan together with the designer.

2,leveling:theso-aledleveling,immediatelybeforethepavingofwoodbrick,shouldbepastedontheuildingfloororwal surfacetreatmentSuchsround,interoralsexteriorwalls,tc.emoveurfaceatahmentsndfatenwitmwet waterand sediment.

3,elasticline:elasticliereferstoalonfinelinecoatedwithiteinkdeterminetheentralaxisoftebrickndtpste according to the line.

4,choosebrick:wanttoseethevarietyofthebrickthattheplanspreads,choosetocomeoutclassifyputwell.Forstance thewoodgrainickofewodgainicktatspreadsgoundrickaorlisouldferetate,stspradsei

5,dipbrick:woodgrainbrickandpolishedbrickntiquebricktosoakwater,tousetapwaterorcleanwatercannotusemuddy waterordirtywaterbutalsocannotuseoilsewage;Soakingtimedoesnotneedtobetoolong,thatistosaysoakingwet (The tiles must be soaked through before being laid)

6.Slurry mixing:waterandsedimentshouldbemixedinaratioof1:2.Cementwithalabelof less than2OOshould beused

7.Grouting:takeoutthesoakedwoodbricks,wipeoffthewaterstainsofthewoodbricks,evenlyapplythecementslurryon thebackof thewoodbricks,withthemortarthickness of 2 - 3 \mathsf {cm } thenspreadthewoodbricksto thewaterandsandsurface of the ground,and gently knock the wood hammeron the wood brick surface untilit is smooth and neat.

8.Paving:Payattentiontothetexturesequenceofwoodgrainbricksandthemarkofarrowonthebottomofwoodgrainbricks. Avoidemptyknockingwithwoodhammerbalancetheforceandavoidtoomuchrtoolitleforce.It'sbesttouseaplastic crossforbricklaying,whichwilbeterpositionthewood-grainbricks.Awoodenhammerstrikesthebackflowofcementslurry betweenwoodgrainbrickjointsandflatersitwithaspongeorrag.Generalgapofhigh-gradewoodgrainbrickisless than1 millimeter,do not need special fill seam.

9.Finishing:Whenthewoodgrainbricksarelaidandthecementisnotcompletelydrythewoodgrainbrickscanbedressed accordingtothestandardbyvisualobservationorhorizontalmeasurement.Checktheflatnessoftileplacement,straightness of tile joints,etc.Findtheproblem,immediatelyrepair,seriouslypryopenthewood-grainbrickandre-laypaste.

10.Seamfiling:Ifyouwantofillteseamuseironhooktomarktheseamafterthecementdriesndthenmatchthecolorof theseam fillingagent.

PS